Tire And Rim Labels; Epa Emission Control - freightliner CENTURY CLASS S Driver Manual

11/01/95

1. Tire and Rim Labels

Fig. 1.4, Labels Location
09/28/98
Fig. 1.5, Incomplete Vehicle Certification Label, U.S.
10/10/2006
Fig. 1.6, Canadian National Safety Mark
post, and certifies that the vehicle conforms to all
applicable CMVSS regulations in effect on the date
of completion.
1
2
f601086
2. Certification Label
f080023
f080024
Vehicle Identification
Tire and Rim Labels
Tire and rim labels certify suitable tire and rim combi-
nations that can be installed on the vehicle, for the
given gross axle weight rating. Tires and rims in-
stalled on the vehicle at the time of manufacture may
have a higher load capacity than that certified by the
tire and rim label. If the tires and rims currently on
the vehicle have a lower load capacity than that
shown on the tire and rim label, then the tires and
rims determine the load limitations on each of the
axles. See Fig. 1.3.

EPA Emission Control

Vehicle Noise Emission Control Label
A vehicle noise emission control label
attached either to the left side of the dashboard or to
the top-right surface of the frontwall between the
dash and the windshield.
VEHICLE NOISE EMISSION CONTROL INFORMATION
FREIGHTLINER CORPORATION
THIS VEHICLE CONFORMS TO U.S. EPA REGULATIONS FOR NOISE EMISSION
APPLICABLE TO MEDIUM AND HEAVY TRUCKS.
THE FOLLOWING ACTS OR THE CAUSING THEREOF BY ANY PERSON ARE PROHIBITED BY
THE NOISE CONTROL ACT OF 1972:
A. THE REMOVAL OR RENDERING INOPERATIVE, OTHER THAN FOR PURPOSES OF
MAINTENANCE, REPAIR, OR REPLACEMENT, OF ANY NOISE CONTROL DEVICE OR
ELEMENT OF DESIGN (LISTED IN THE OWNER'S MANUAL) INCORPORATED INTO THIS
VEHICLE IN COMPLIANCE WITH THE NOISE CONTROL ACT.
B. THE USE THIS VEHICLE AFTER SUCH DEVICE OR ELEMENT OF DESIGN HAS
BEEN REMOVED OR RENDERED INOPERATIVE.
10/06/98
Fig. 1.7, Vehicle Noise Emission Control Label
IMPORTANT: Certain Freightliner incomplete
vehicles may be produced with incomplete noise
control hardware. Such vehicles will not have a
vehicle noise emission control information label.
For such vehicles, it is the final-stage manufac-
turer's responsibility to complete the vehicle in
conformity to U.S. EPA regulations (40 CFR Part
205) and label it for compliance.
EPA07 Exhaust Emissions
Regulations
To meet January 2007 emissions regulations, en-
gines manufactured after January 1, 2007, are
equipped with an emission aftertreatment device.
There is a warning label on the driver's sunvisor, ex-
plaining important new warning indicators in the driv-
er's message display, that pertain to the aftertreat-
ment system. See Fig.
(Fig. 1.7) is
01/96
DATE OF MANUFACTURE
24−00273−020
1.8.
f080026
1.2