International comfort products NAHA00101MH Installation Instructions Manual page 5

Manufactured (mobile) home kit condensing gas furnace conversion
Table of Contents

Advertisement

7. Connect the connector harness to gas valve.
NOTE: Use only propane−resistant pipe dope. Do not use
Teflon tape.
8. Insert the gas pipe through the grommet in the casing.
Apply a thin layer of pipe dope to the threads of the pipe
and thread the pipe into the gas valve.
NOTE: Use a back−up wrench on the gas valve to prevent the
valve from rotating on the manifold or damaging the mounting
to the burner box.
9. With a back−up wrench on the inlet boss of the gas
valve, finish tightening the gas pipe to the gas valve.
10. Check for leaks after the gas pipe is installed.
NOTE: If you are converting furnace for use with propane,
attach kit labels and extra parts bag as described in Procedure
3 then proceed to Section II.
Figure 5
Conversion Responsibility Label
Figure 6
Conversion Rating Plate Label Location
FURNACE CONVERSION
RATING PLATE
REPRESENTATIVE DRAWING ONLY, SOME MODELS MAY VARY.
443 06 4002 00
Procedure 3 — Label and Extra Parts Bag Attachment
NOTE: See Figure 6, Figure 7 and Figure 8 for label location.
1. Attach Conversion Responsibility Label (337993−101)
2. Attach Conversion Rating Plate Label (338299−101)
3. Attach Manufactured (Mobile) Home Installation Label
4. Attach adhesive pouch (337985−101) containing gas
5. Proceed to Section II or III for gas type modification and
Figure 7
Specifications subject to change without notice.
inside of main furnace door. (See Figure 7) Date, name,
and address of organization making this conversion are
required. (See Figure 5)
inside of lower left−hand side of controls compartment
(downflow) as shown in Figure 6.
(322236−101) inside of main furnace door. (See
Figure 7)
orifices and Installation Instructions to front of main
furnace door or accessible furnace side. (See Figure 1
or Figure 8)
Input rate adjustment.
Installation & Responsibility Label Locations
MANUFACTURED (MOBILE)
HOME INSTALLATION LABEL
INSIDE OF DOORS
RESPONSIBILITY LABEL
REPRESENTATIVE DRAWING ONLY, SOME MODELS MAY VARY.
5

Advertisement

Table of Contents
loading

Table of Contents