Advertisement
8)
Put in ABS/PLA :
1) Turn on the power of printer, the printer LED screen will appear: Build from SD
2) Select "Utilities", click "M"of button plat , it will appear: Montior Mde
3) Select"Change filament", click "M"of button plat, it will appear: Load Right
4) Select"Load right", click "M"of button plat, it will appear : I'm heating up, my extruder!
the temperature of right nozzle is warming now, when it reaches 220℃, nozzle will start work, if
it does work, you can click several times of "M"until the nozzle working (left nozzle put in
ABS/PLA working process as same as right nozzle, also choose
Put out ABS/PLA :
1) Turn on the power of printer, the printer LED screen will appear: Build from SD
2)Select "Utilities", click "M"of button plat, it will appear: Montior Mde
Put in /out material
Preheat
Utilities
Preheat
Utilities
Change filament
Level Build Plate
Home Axes
Unload Right
Load Left
Unload Left
load left
Change filament
Level Build Plate
Home Axes
)
Advertisement
