Draytek VIGOR2950 User Manual page 100

SSL Tunnel
Specify Remote Node
Netbios Naming Packet
SSL VPN
92
Must -Specify the IPSec policy to be definitely applied on the
L2TP connection.
It allows the remote dial-in user to make an SSL VPN
Tunnel connection through Internet, suitable for the
application through network accessing (e.g.,
PPTP/L2TP/IPSec)
If you check this box, the function of SSL Tunnel for this
account will be activated immediately.
To check if SSL Tunnel is activated or not, please open
Draytek SSL VPN portal interface. From the web page, you
will see the message to indicate the SSL Tunnel is activated.
Check the checkbox-You can specify the IP address of the
remote dial-in user, ISDN number or peer ID (used in IKE
aggressive mode).
Uncheck the checkbox-This means the connection type you
select above will apply the authentication methods and
security methods in the general settings.
Pass – click it to have an inquiry for data transmission
between the hosts located on both sides of VPN Tunnel while
connecting.
Block – When there is conflict occurred between the hosts on
both sides of VPN Tunnel in connecting, such function can
block data transmission of Netbios Naming Packet inside the
tunnel.
It allows the remote dial-in user to access internal web over
SSL VPN, suitable for the application through web only (e.g.,
HTTP). Click Set SSL Web Proxy to set profiles.
If you have set several profiles beforehand, you can check
SSL Web Proxy and choose the one(s) you need as SSL VPN.
Vigor2950 Series User's Guide