Understanding The Basics; Turning Your Tv On Or Off; Selecting The Video Input Source - Insignia NS-46E570A11 User Manual

9 Press OK/ENTER. The Choose your Picture Mode
screen opens.
OK
MOVE
ENTER
Reduces total power consumption
10 Press or to highlight Home Mode (default)
or Retail Mode, then press OK/ENTER.
If you selected Retail Mode, a message appears
"Are you sure you want Retail mode? Since in
this mode Energy saving is not realized. " Select
Yes to continue, or select No to change your
selection.
The Choose your TV source screen opens.
Antenna
Cable
Cable/Satellite box
OK
MOVE
ENTER
Channel scan may take 20+ minutes
11 Press or to highlight Antenna, Cable, or
Cable/Satellite Box (if your cable TV uses a box,
select Cable/Satellite Box), then press
OK/ENTER. If you chose Antenna or Cable, your
TV automatically starts scanning for channels
available in your viewing area. If you chose
Cable/Satellite box, your TV does not need to
scan for channels.
During auto channel search, your TV searches
for digital channels first. If you chose Antenna,
when the digital channel search is complete, a
message appears asking if you want to search
for analog channels. If you do not need to
search for analog channels, press MENU or EXIT
stop searching for channels.
When the scan is complete, the Setup Wizard
closes automatically.
Note
You can press EXIT to stop the auto channel search,
but you will need to run the auto channel search
again to create a channel list.
14
NS-42E570A11/NS-46E570A11 Insignia 42"/46" LED-LCD TV, 120Hz 1080p
Choose your Picture Mode
Home Mode
Retail Mode
SELECT PREVIOUS EXIT
MENU EXIT
Choose your TV source
0 Digital Channels
0 Analog Channels
Scanning for digital channels
SELECT PREVIOUS
MENU EXIT
www.insigniaproducts.com

Understanding the basics

Note

Turning your TV on or off

To turn your TV on or off:
1 Make sure that the power cord is connected to a
power outlet.
2 Press
indicator LED turns blue.
3 Press
TV enters Standby mode and the power
indicator LED turns red.
Warning
Note

Selecting the video input source

To select the video input source:
1 Turn on your TV, then press INPUT. The Source
List opens.
EXIT
2 Press
then press OK/ENTER.
You can also press a direct input button to select
the video input source.
• Press TV to select TV.
• Press COMP to select Component.
• Press HDMI once to select HDMI 1.
• Press HDMI twice to select HDMI 2.
• Press HDMI three times to select HDMI 3.
• Press HDMI four times to select HDMI 4.
Note
Unless otherwise noted, all tasks in this section are
based on using the remote control.
(power) to turn on your TV. The power
(power) again to turn off your TV. Your
When your TV is in Standby mode, it is still receiving
power. To completely disconnect power, unplug the
power cord.
If your TV does not receive an input signal for several
minutes, it automatically goes into Standby mode.
Source List
TV
Component
VGA
HDMI 1
HDMI 2
HDMI 3
HDMI 4
USB
or to highlight a video input source,
If Auto Input Sensing is set to On, only the jacks that
have connected devices are active. The other inputs
are grayed and cannot be selected.