Download Print this page

What To Do In The Event Of A Problem - Hitachi H4021 Quick Setup Manual

Advertisement

6
Event
The POWER LED is not lit
I can't connect to the Internet in Ethernet mode
I can't configure my Modem in Wi-Fi mode
I can't use my Modem in Wi-Fi mode
Wi-Fi is properly configured but I still can't connect in
Wi-Fi mode
I can't connect in USB mode
I can't connect multiple computers to the Modem
I can't surf the Internet
My Internet page "freezes"
When I pick up the telephone, I hear a loud buzz
For non-technical issues: 0805 02 4000 (free call)

What to do in the event of a problem?

Test procedure or possible cause
Check that the power supply block is properly plugged in.
Check that the power supply cable is properly connected to your terminal.
Check that the electrical socket is working correctly and that your electrical supply is on (power cut...).
Check that the yellow Ethernet cable is properly connected to your computer and Modem.
Also check that your computer is properly configured (network configuration menu).
By default, the Wi-Fi port is disabled. It must be activated through the Web interface by clicking on the "Wireless" menu and then
ticking the "Enable Wireless" box (refer to the Wi-Fi configuration page).
Check that the WEP encryption key has been properly entered in your Wi-Fi receiver and that the key entered is the one that is
printed on the bottom of the Modem.
Check that the Modem is working properly, that your computer's Wi-Fi adapter uses WEP 128 encryption and that you have
properly entered the WEP key printed on the bottom of your Modem.
Then eventually, move your Wi-Fi terminal closer to the Modem.
Using USB requires the installation of drivers on your computer. These drivers are not supplied by default, but you can download
them from our website or by calling technical support.
However: the use of USB is not recommended.
Check that each new computer is correctly connected to the Modem (either in Ethernet, USB or Wi-Fi mode) and that the used
mode is correctly configured on each computer.
Reboot the modem using the ON/OFF switch on the rear face of the modem
Reboot the computer.
You probably have not placed an ADSL filter on your main or secondary telephone wall socket.
FREE Technical Support Hotline
open Monday-Thursday 9:30am-6pm, Friday 9:30am-5pm
by phone: 0805 111 555 (free call)
or by e-mail: support@teleconnect.fr

Advertisement

loading