Table of Contents
Advertisement
R-209BW
The I/O signal of the LSI are detailed in the following table.
Pin No.
Signal
1
RESET
2
TEST
3
VSS
4
OCS3
5
OCS4
OUT
6
VD1
7
VDD
8
AVDD
9
AVREF
10
AVSS
11-13
P40-P42
14
P43
15
BZ
OUT
16
R00
OUT
17
R01
OUT
18
R02
OUT
19
R03
OUT
20
P20
OUT
21
P21
OUT
22
P22
OUT
DESCRIPTION OF LSI
I/O
IN
Auto clear terminal.
Signal is input to reset the LSI to the initial state when power is supplied. Temporarily
set to "L" level the moment power is supplied, at this time the LSI is reset. Thereafter
set at "H" level.
IN
Connected to GND.
IN
Power source voltage: -5V.
VSS voltage of power source circuit input. Connected to VC.
IN
Internal clock oscillation frequency setting input.
The internal clock frequency is set by inserting the resistor oscillation circuit with
respect to OCS4 terminal.
Internal clock oscillation frequency control output.
Output to control oscillation input of OCS3.
IN
Power source for oscillation circuit.
IN
Power source voltage input terminal.
Connected to GND.
IN
A/D converter power source voltage.
The power source voltage to drive the A/D converter in the LSI. Connected to GND.
IN
A/D converter power source voltage.
The power source voltage to drive the A/D converter in the LSI. Connected to GND.
IN
Power source voltage: -5V.
AVSS voltage of power source circuit input. Connected to VC.
IN
Terminal to change functions according to the Model.
By using the A/D converter contained in the LSI, DC voltage in accordance with the
Model in operation is applied to set up its function.
IN
To input signal which communicates the door open/close information to LSI.
Door close "H" level signal (0V). Door open "L" level (-5V).
Signal to sound buzzer (2.0 kHz).
A: key touch sound.
B: Completion sound.
Key strobe signal.
Signal applied to touch-key section. A pulse signal is input to P23, K00, K01 and K02
terminal while one of G6 line keys on key matrix is touched.
Key strobe signal.
Signal applied to touch-key section. A pulse signal is input to P23, K00, K01 and K02
terminal while one of G5 line keys on key matrix is touched.
Key strobe signal.
Signal applied to touch-key section. A pulse signal is input to P23, K00, K01 and K02
terminal while one of G4 line keys on key matrix is touched.
Key strobe signal.
SigM nal applied to touch-key section. A pulse signal is input to P23, K00, K01 and K02
terminal while one of G3 line keys on key matrix is touched.
Key strobe signal.
Signal applied to touch-key section. A pulse signal is input to P23, K00, K01 and K02
terminal while one of G2 line keys on key matrix is touched.
Key strobe signal.
Signal applied to touch-key section. A pulse signal is input to P23, K00, K01 and K02
terminal while one of G1 line keys on key matrix is touched.
Terminal not used.
Description
A
B
8
0.1 sec.
H : GND
L : -5V
2.0 sec.
H : GND
L : -5V
Advertisement
Table of Contents
