Advanced Setup - 1 Source S1-THEU21P7S Owner's Manual

OWNER'S MANUAL

Advanced Setup

This is normally done by the installer at initial installation.
Press the PROGRAM button to enter the Advanced Setup.
When the clock is flashing, press the NEXT button for
5 seconds. Do not release the button until this screen
appears.
Press NEXT
to advance
NEXT
6
Press NEXT
to advance
NEXT
Press NEXT
to advance
NEXT
Press NEXT
to advance
NEXT
Press NEXT
to advance
NEXT
S1-THEU21P7S
Use these buttons to
adjust the deadband
from 1 to 6 degrees
(page 17).
Use these buttons to
adjust the Cycles Per Hour
from 2 to 6.
d=no limit (zoning)
d1=d+no compressor
lockout (page 17).
Select backlight operation
when a button is pressed:
OFF: Light for 8 seconds after
a button press.
ON: Light continuously.
Use these buttons to select
thermostat operation in
degrees F or C.
ON = Heat Pump
operation
OFF = Gas Electric
operation
Page 15