Psw Circuit Board; Handle - Yamaha P5000S Service Manual

12. PSW Circuit Board (Time required: about
10 min.)
12-1 Remove the front panel part. (See procedure 8.)
12-2 Remove the power switch escutcheon marked
[400]. (Fig.13)
12-3 It presses lightly from the panel back and remove
the power switch knob marked [100].
* When it is hard to remove the power switch
knob, insert an L-shaped rod into the gap and pull
out the knob as shown the illustration. (Fig.14)
Be careful so as not to bruise a panel and a knob
at this time.
12-4 Remove the two (2) screws marked [90].
The PSW circuit board can then be removed.
(Fig.12)
[400]
[400]: Power Switch Escutcheon (WD345700)
13. Handle (Time required: about 6 min.)
13-1 Remove the front panel part. (See procedure 8.)
13-2 Remove the two (2) screws marked [390] for each
side.
The handles can then be removed. (Fig.15)
*The handle angle is removed simultaneously, at
this time.
Handle Angle
(Fig.13)
[390]: Bind Head Screw SP 5.0X16 MFZN2BL (VU68800)
[100]: Power Switch Knob (WD345600)
[390]
(Fig.15)
P5000S/P7000S
[100]
(Fig.14)
Handle Angle
19