Out1 Circuit Board; Out2 Circuit Board - Yamaha P5000S Service Manual

P5000S/P7000S
[280]
[270]
[270]: Hex Spacer H=24.5 B=5.5 (WD490100)
[280]: Bind Head Tapping Screw-S 3.0X6 MFZN2BL (EP630210) +
6. OUT1 Circuit Board (Time required: about 4
min.)
6-1 Remove the rack angle. (See procedure 1.)
6-2 Remove the top cover. (See procedure 2.)
6-3 Remove the four (4) screws marked [320]. (Fig.1)
6-4 Remove the two (2) hexagonal nuts marked [C].
The OUT1 circuit board can then be removed. (Fig.1)
* The OUT1 circuit board and the OUT2 circuit board
are connected by the connector assembly W607.
7. OUT2 Circuit Board (Time required: about 5
min.)
7-1 Remove the rack angle. (See procedure 1.)
7-2 Remove the top cover. (See procedure 2.)
7-3 Remove the OUT1 circuit board. (See procedure 6.)
7-4 Remove the two (2) screws marked [510].
Remove the SP terminal cover marked [500]. (Fig.1)
7-5 Remove the two (2) screws marked [310]. (Fig.6)
7-6 Because the OUT2 circuit board and the IN circuit
board are connected by the connector assembly
W301, it removes the solder of terminal W301B.
The OUT2 circuit board (and the OUT1 circuit
board) can then be removed.
16
[270]
[280]
(Fig.4)
[310]: Bind Head Tapping Screw-B 3.0X10 MFZN2BL (VQ049800) +
[310]
(Fig.6)
(Fig.5)