Panasonic PP103909 Operating Instructions Manual page 18

Troubleshooting
p Radio
Trouble
Much noise in FM
stereo and monaural
broad casts.
p CD
Trouble
Disc is in the CD com-
partment but no sound
is made, or disc is
ejected automatically.
Sound skips, bad sound
quality. (e.g. caused by
noise)
Sound skips due to
vibration.
Disc is not ejected.
Time is counted but no
sound comes out.
18
(Continued)
Station is too far, or signals are too weak.
a Select other stations of higher signal level.
The radio antenna is not extended enough.
a Extend fully the radio antenna.
Disc is upside down.
a Place disc in the correct direction with the label side up.
• Disc is dirty.
• Disc has scratches.
a
Clean disc, referring to the section on "Notes on Discs".
A disc that has data other than CD-DA type is loaded.
a Discs that have CD-DA type data should be used.
a The unit may not successfully playback a CD-R/RW that is made in
combination of writing software, a CD recorder (CD-R/RW drive) and
a disc which are incompatible one another. Refer to instructions for
the concerned devices for details.
• Disc is dirty.
• Disc has scratches.
a Clean disc, referring to the section on "Notes on Discs".
a
The unit may not successfully playback a CD-R/RW that is made in
combination of writing software, a CD recorder (CD-R/RW drive) and
a disc which are incompatible one another. Refer to instructions for
the concerned devices for details.
Mounting angle is over 30˚.
a Adjust mounting angle to less than 30˚.
Instable mounting.
a Mount the unit securely with the mounting parts.
• Disc is defective.
• Mechanical trouble.
a Press [u] (eject). If normal operation is not restored, consult your
dealership for repairs.
The first track of a mix mode disc was reproduced. (Mix mode is a format
in which data except music is recorded on the first track and music data is
recorded on other than the first track in a session.)
a Playback music data recorded on other than the first track.
Check point
Check point