GOGOGATE Garage Door Opener User Manual page 24

I have completed the programming sequence and heard the 3 beeps but my WIFI is not blinking?
This means the GoGogate cannot connect to your wireless network. There are 5 possible causes:
• Gogogate is not compatible with "hidden" SSID.
You are using network that works at 5GHz. GoGogate only works at 2.4Ghz.
•
• You SSID/Network name may contain special characters such as: " & / ' that are not supported.
Your encryption is not supported. Gogogate works with WPA-PSK, WPA2-PSK, and WEP 128 bits.
•
try to change your encryption settings.
• Gogogate is out of range of your WiFi network. You can check this by looking at your Smartphone. If your
Smartphone has WiFi coverage where your GoGogate device is located, then your GoGogate device
should also be within range of your network.
FOLLOW INSTRUCTIONS BELOW ONLY IF YOUR GOGOGATE PROGRAMMING HAS FAILED.
Using your PC, you will need to gain access to the WEB page of your router. This is the web page you used
to configure your router when you first installed it. You can find this information in your router user manual.
The address is usually something like http://192.168.1.1
After reading the above recommendations, the first thing you should do is unplug the GoGogate, wait for
10 seconds and plug it again. Once STATUS light starts blinking, try to re-program the device once again.
1) Reset the GoGogate unit by pressing the RESET button for 5 seconds until you hear 1 beep.
2) Access your router and change your Network Name to "Connect" (with Capital "C" ) and without encryption
(ie. Open network).
3) The GoGogate will connect automatically to your Network Name and your USB WiFi will start blinking.
4) Connect your smartphone to "Connect" network.
5) In the GoGogate APP, go to Settings → Guest access, and enter: GoGogate name: "home"
password"12345678". Press save changes and go Back to main screen.
6) You are now connected to your GoGogate.
7) Press "Find GoGogate" on the main APP Screen
8) Enter "admin" as a password.
9) Go to WiFi Settings and enter your original network name, encryption and password.
10) Click on update.
11) Access your router and replace the Network name "Connect" with your original network name (same you
entered in the GoGogate), encryption and password.
You are done!! Your GoGogate device should now operate properly.
24