Performance ViewPoint Single Pro Owner's Manual page 2

3. Loop the strap through the "D" ring and
maneuver it back down through the
same hole (see Figure 3).
4. Once the strap has been pulled
tight, secure the light using the
provided Velcro
5. To operate: To turn the headlamp
on and off, push the button switch
on the back of the headlamp housing.
6. The headlight can be aimed by rotating the assembly up or
down. After obtaining proper beam adjustment, securely tighten
the clamp bolt.
7. Your ViewPoint™ Single Pro comes with a 12-watt spot beam bulb. Other
bulbs are available to customize your light to the type of riding that you
do. Refer to the section on changing bulbs. Please note that using a bulb
of higher wattage will reduce the run time of your light.
NOTE: The high wattage bulb causes the aluminum housing to get very hot
when the light is in use. Therefore, DO NOT TOUCH ALUMINUM HOUSING
WHILE THE LIGHT IS IN USE. Please use caution to avoid burning yourself.
For optimum durability, your ViewPoint
a way as to keep air flowing over the system.
® .
Fig. 2
™ light should be mounted in such
Fig. 3
Fig. 1