Magic Remote Functions - LG 98UB9800 Owner's Manual

MAGIC REMOTE FUNCTIONS

When the message Magic remote battery is low. Change the battery . is displayed,
replace the battery. To install batteries, open the battery cover, replace batteries
(1.5 V AA) matching
the battery cover. Failure to match the correct polarities of the battery may cause
the battery to burst or leak, resulting in fire, personal injury, or ambient pollution. Be sure to point
the remote control at the remote control sensor on the TV. To remove the batteries, perform the
installation actions in reverse.
CAUTION
• Do not mix old and new batteries, as this may damage the remote control.
This remote uses infrared light. When in use, it should be pointed in the direction of the TV's remote sensor.
(For 98UB9800, 98UB9810)
Turns the TV on or off.
Returns to the previous screen.
Press the center of the Wheel
button to select a menu. You can
change channels by using the
Wheel button.
(EXIT to LIVE)
Switches among broadcast
(antenna) and various inputs.
Color buttons
These access special functions in
some menus.
( : Red,
: Yellow,
Adjusts the volume level.
Displays the Screen Remote.
• Accesses the Universal Control
Menu in some regions.
• Pressing and holding the
button will display a menu to
select an external device that is
connected to the TV.
Used for viewing 3D video.
Mutes all sounds.
• By pressing and holding the
button, VD function will be
• SAP (Secondary Audio Program)
Feature can also be enabled by
pressing the
Scrolls through the saved
and ends to the label inside the compartment, and close
(POWER)
(BACK)
Wheel (OK)
: Green,
VOL
: Blue)
VOL
(MUTE)
enabled.
key.
CH
channels.
MAGIC REMOTE FUNCTIONS
(Home)
Accesses the Home menu.
Press the up, down, left or right
button to scroll the menu. If you
press
pointer is in use, the pointer will
disappear from the screen and
Magic Remote will operate like a
general remote control. To display
the pointer on the screen again,
shake Magic Remote to the left
and right.
(Voice recognition)
/INPUT Network connection is required
CH
to use the voice recognition
function.
1. Press the voice recognition
button.
2. Speak when the voice display
window appears on the left of
the TV screen.
• Use the Magic Remote no
further than 10 cm (4 inches)
from your face.
• The voice recognition may fail
when you speak too fast or too
slowly.
• The recognition rate may
vary depending upon the
user's characteristics (voice,
pronunciation, intonation, and
speed) and the environment
(noise and TV volume).
(up/down/left/right)
buttons while the
35