Advertisement
1. FRONT WHEEL Required tools – 15mm wrench or adjustable wrench
Position the fork so that it is facing forward as in the picture below. Remove the outside 15mm nut and safety washer
from each side of the axle. Slide wheel axle into the slots at the bottom of the fork. Place a safety washer on each side of
the axle. The smaller end of the washer should be facing the fork. Ensure that the narrow portion of the safety washer is
seated fully into the rounded portion of the fork dropout. Carefully thread on a 15mm nut to each end and tighten with a
wrench.
2. FRONT FENDER Required tools - two 10mm wrenches or two adjustable wrenches
Find the fender mounting bolt through the top of the fork. Remove the nut and washer. Attach the fender with the
mounting bolt through the fender bracket. Replace washer and carefully rethread the nut. Adjust fender so that it is not
rubbing on the tire as the wheel is turned. Tighten the bolt and nut.
Correct washer
placement
QUESTIONS: Should you have any questions during the final assembly of your new bicycle, please call our product 4/4/11
specialists at 800-226-7552 any day between 8:00 a.m. and 10:00 p.m. Eastern.
Assembly Instructions
Fork in
correct
forward
position
Dropout
portion
of fork
Safety
washer
and 15mm
nut in
proper
position
pg.2
Advertisement
