Accessories And Attachments - DeWalt DWE4000-XE Instruction Manual

Attaching Side Handle (Fig. 1)
WARNING: Before using the tool, check that the handle is tightened securely.
Screw the side handle (C) tightly into one of the holes on either side of the gear case.
The side handle should always be used to maintain control of the tool at all times.

Accessories and Attachments

It is important to choose the correct guards, backing pads and flanges to use with
grinder accessories. Refer to chart on pages 8 and 9 for information on choosing the
correct accessories.
NOTE: Edge grinding and cutting can be performed with Type 27 wheels designed and
specified for this purpose.
WARNING: Accessories must be rated for at least the speed recom mended on the
tool warning label. Wheels and other accessories running over rated accessory speed
may burst and cause injury. Threaded accessories must have an M10 hub. Every
unthreaded accessory must have a 16 mm arbor hole.
If it does not, it may have been designed for a circular saw and should not be used.
Use only the accessories shown in chart on pages 8 and 9. Accessory ratings must
be above listed minimum wheel speed as shown on tool nameplate.
Mounting Guards
CAUTION: Guards must be used with this grinder.
NOTE: Please refer to the Grinding and Cutting Accessory Chart on pages 8 and 9 to
see other accessories that can be used with these grinders.
MOUNTING AND REMOVING (TYPE 27) ONE-TOUCH GUARD (FIG. 2)
NOTE: If your grinder is supplied with a keyless One-Touch guard, ensure the screw
and spring are fitted correctly before mounting the guard
1. Press the guard release lever (H).
2. While holding the guard release lever open, align the lugs (I) on the guard (F) with
the slots on the gear case (J).
3. Keeping the guard release lever open, push the guard down until the guard engages
the lugs and rotate them in the groove on the gear case hub. Release the guard
release lever.
115 mm and 125 mm (4-1/2" and 5") Sanding Flap Discs
Type 27 guard
Hubbed sanding flap
disc
8
Type 27 guard
Quick-change
backing flange
Non-hubbed sanding flap
disc
Threaded clamp nut