Cisco AIRONET 340 Series Quick Start Manual page 9

Determine Configuration Method (continued)
5
Enter the bridge's MAC address in the Device MAC ID field. The bridge's MAC address is
printed on the label on the bottom of the unit. It should contain six pairs of hexadecimal
digits. Your bridge's MAC address might look like the following example: 11223a4D5566.
Note
The MAC address field is not case-sensitive.
6
In the IP Address field, enter the IP address the network administrator gave you to assign
to the bridge. The IP address of the PC should be on the same subnet as the IP address you
are assigning to the bridge.
7
Enter the SSID you want to assign to the bridge in the SSID field.
Note
You cannot set the SSID without also setting the IP address. However, you can set the
IP address without setting the SSID.
8
Click Set Parameters.
9
To test the IP address, open an Internet browser.
10
Enter the bridge's IP address in the browser's location or address field. (If you are using
Netscape, the field is labeled Netsite or Location; if you are using Microsoft Explorer, the
field is labeled Address.)
11
Press Enter. The bridge's main menu page appears.
7