Table of Contents
Advertisement
Pin
Hemstitch and edging
For these two tasks proceed as follows:
1. In the section "Adjusting the sewing foot" reread
the instructions for adjusting the sewing foot o.
2. Turn the handwheel 6 to yourself until the needles
stand fully at the top.
3. Open the front flap 8 and remove the left needle
(see section " Exchanging needles").
4. Adjust the stitching length to 1.0 - 2.0 mm. Ensure
that the adjustment wheel for the differential
feed motion u is placed at "N".
5. Adjust the stitching width as described in the sec-
tion "Setting the cutting width".
6. If a yarn is not threaded, now rethread a new
yarn.
7. Lay your material under the sewing foot o and
start to sew.
Note:
Before you begin to sew on your actual workpiece,
always check the adjustments for stitching length
and thread tension on a material remnant.
Note:
Always remember to return the adjustment for the
sewing foot o from this special to normal operation
(sewing tasks) after the sewing of hems.
Sewing hemstitch
With the sewing of hemstitches the loops of the upper
looper thread should be pulled back to the underside
of the material. This is achieved by adjustment of the
thread tension, as described in the section "Setting
the thread tension".
lower
looper thread
Sewing narrow edging
If you wish to sew very thin or light materials, select
a suitable thread tension, as described in the sec-
tion "Setting the thread tension".
needle thread
- 17 -
upper
looper thread
upper
looper thread
lower
looper thread
Hide quick links:
Advertisement
Table of Contents
