The Proximity Effect; Stand Mounting The C7 - Miktek C7 Owner's Manual

Large diaphragm multi-pattern fet condenser microphone
Table of Contents

Advertisement

Operating the C7
monitor the signal through a set of good quality closed-back headphones and take notice to how just a slight adjustment
can make a huge change in frequency response As you're changing the microphone's position, be sure to check that the
mic input is still set to a good level without clipping, as described in the previous section

The Proximity Effect

All cardioid or uni-directional microphones exhibit a phenomenon known as "proximity effect" The proximity effect is
the increase in low frequency response a microphone exhibits as it is moved closer to the sound source Vocalist tend
to love this effect since when they get really close to the mic they get the "FM radio", big bass sound A good vocalist
with good mic technique will use the proximity effect to adjust their tonal response in real time The key to developing
the best mic technique is experimentation, along with awareness of the general principle that, when the pattern
switch is set to Cardioid, the closer your C7 is to a signal source, the greater the bass response The proximity effect's
bass lift is caused by the amount of pressure present at the ports that are used to create the directional pattern Since
omnidirectional microphones do not normally have ports, they do not have proximity effect

Stand Mounting the C7

The C7 can be mounted to any standard microphone stand using the included mic stand holder or the SM7 shock-mount
If you are using a US standard 5/8-inch mic stand, remove the Euro adapter by unscrewing it from the mic holder Screw
the holder to a solid mic stand, then line up the bottom threaded section of the C7 to the holder and slowly rotate the
microphone clockwise until it screws on hand tight Be careful not to cross thread the screws You can loosen the bottom
thumbscrew on the holder to make left and right adjustments to the mic, and then re-tighten it once it's in place Loosen
the side thumbscrew to set the microphone angle and then tighten once it's in place
9

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the C7 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Table of Contents