The Proximity Effect; Stand Mounting The Cv3 - Miktek CV3MP Owner's Manual

Operating the CV3

The Proximity Effect

All cardioid or uni-directional microphones exhibit a phenomenon known as "proximity effect" The proximity effect is
the increase in low frequency response a microphone exhibits as it is moved closer to the sound source Vocalist tend
to love this effect since when they get really close to the mic they get the "FM radio", big bass sound A good vocalist
with good mic technique will use the proximity effect to adjust their tonal response in real time The key to developing
the best mic technique is experimentation along with awareness of the general principle that, when the pattern switch
is set to Cardioid, and the closer your CV3 is to a signal source, the greater the bass response The proximity effect's
bass lift is caused by the amount of pressure present at the ports that are used to create the directional pattern Since
omnidirectional microphones do not normally use these ports, they do not have proximity effect

Stand Mounting the CV3

The CV3 can be mounted to any standard microphone stand using the included mic stand holder or the SM7 shock-
mount If you are using a US standard 5/8-inch mic stand, remove the Euro adapter by unscrewing it from the mic holder
Screw the holder to a solid mic stand, then line up the bottom threaded section of the CV3 to the holder and slowly
rotate the microphone clockwise until it screws on hand tight Be careful not to cross thread the screws You can loosen
the bottom thumbscrew on the holder to make left and right adjustments to the mic, and then re-tighten it once it's in
place Loosen the side thumbscrew to set the microphone angle and then tighten once it's in place
9