Mechanical Adjustments; Electrical Adjustments; Deck Section - Aiwa CX-LEM330 Service Manual

QQ
3 7 63 1515 0

MECHANICAL ADJUSTMENTS

TAPE MECHANISM DECK SECTION
Precaution
1. Clean the following parts with a denatured alcohol-moistened
swab:
record/playback heads pinch rollers
erase head
capstan
2. Demagnetize the record/playback head with a head
demagnetizer.
3. Do not use a magnetized screwdriver for the adjustments.
4. After the adjustments, apply suitable locking compound to
the parts adjusted.
5. The adjustments should be performed with the rated power
supply voltage unless otherwise noted.
Torque Measurement
Mode Torque meter
FWD CQ-102C
FWD
CQ-102C
back tension
FF/REW CQ-201B
FWD tension CQ-403A
TE
L 13942296513
www
.
http://www.xiaoyu163.com
SECTION 5
rubber belts
idlers
Meter reading
2.94 mN • m to 7.84 mN • m
31 to 71 g • cm
(0.43 – 0.98 oz • inch)
0.14 mN • m to 0.59 mN • m
2 to 6 g • cm
(0.02 – 0.08 oz • inch)
6.86 mN • m to 17.64 mN • m
71 to 143 g • cm
(0.98 – 1.99 oz • inch)
more than 0.98 N • m
100 g or more
(3.53 oz or more)
x ao u163
y
i
http://www.xiaoyu163.com

ELECTRICAL ADJUSTMENTS

2 9
8

DECK SECTION

Precaution
1. Demagnetize the record/playback head with a head
demagnetizer.
2. Do not use a magnetized screwdriver for the adjustments.
3. After the adjustments, apply suitable locking compound to
the parts adjust.
4. The adjustments should be performed with the rated power
supply voltage unless otherwise noted.
5. The adjustments should be performed in the order given in
this service manual. (As a general rule, playback circuit
adjustment should be completed before performing recording
circuit adjustment.)
6. The adjustments should be performed for both L-CH and R-
CH.
7. Switches and controls should be set as follows unless otherwise
specified.
Test Tape
Tape
P-4-A100
WS-48B
Record/Playback Head Azimuth Adjustment
Procedure:
1. Mode: Playback
Q Q
test tape
3 6 7 1 3 1 5
P-4-A100
(10 kHz, – 10 dB)
2. Turn the adjustment screw and check output peaks. If the peaks
do not match for L-CH and R-CH, turn the adjustment screw
so that outputs match within 1dB of peak.
L-CH
peak
R-CH
peak
Screw
position
co
.
CX-LEM330
SECTION 6
9 4 2 8
0 dB = 0.775 V
Signal Used for
10 kHz, –10 dB Azimuth Adjustment
3 kHz, 0 dB Tape Speed Check
MAIN board
0 5 8 2 9 9 4 2 8
SPEAKER terminal (J302)
L-CH, R-CH
level meter
set
+
–
within
1dB
Output
level
L-CH R-CH
peak peak
m
9 9
9 9
within
1dB
Screw
position
13