Quick Reference Guide
4.
Connect the plug of the AC Cord into a 100-240 V AC / 50-60 Hz
Power Outlet.
The total length of the power supply cables is 4.3 m (14.1 ft.).
NOTE
5.
If installed on an AC-powered Cart, secure the Indoor Power Supply
Unit to the AC-powered Cart.
Ground Polarity
CAUTION
Connecting the Telemetry Cable (VC6096 only)
The following example shows the 6 Pin Deutsch Telemetry Cable (p/n
3071815Y146). For detailed description of all telemetry cables, refer to
VC6000 series Product Reference Guide, p/n 6802986C08-x.
Telemetry Cable
1.
Plug the J1 connector into the Auxiliary port of the VC6000 series
(See
Back Features on page
the connector.
2.
Plug connectors J2 and J3 to the telemetry receptacles of your vehi-
cle data bus.
The VC6000 series should operate only in negative
ground electrical systems. Check the ground polarity of
the vehicle before starting the VC6000 series installation
to verify that the polarity is correct. Accidentally reversing
the polarity will not damage the VC6000 series, but will
cause the cable fuse to blow.
7) and fasten the connection screws of
21