DGTEC DG-FV5800 User Manual page 16

3.2.5Sleep
Switch between Lower Power and Normal by pressing left and right buttons.
Press UP, DOWN Key to select items that you want .
Press LEFT, RIGHT Key to change Settings
3.3 Parent Control
Default Pin code is 0000. Please enter this number
when requested.
PG block level (Parental Guidance):
Under this menu, you can choose a Rating of your
choice to block: All/
Disable/R-Above/AV-Above/MA -Above/PG- and
Above/G.
5.3 Pin Setting
To prevent the unauthorized access of your STB, you can set the pin control
password to your receiver. (Default password: 0000)
LEFT or RIGHT
1. Press
password, set to enable.
2. Press the number key 0-9 on the RCU to input Old password.
3. If the password is correct, the cursor can move onto Input New password
option. Press number key 0-9 to input new 4-digit password;
4. To Confirm New Password, press number key 0-9 again.
3.4 Factory default
The factory default enables you to reset your STB
back to factory settings.
WARNING: You will loose all settings and
channels already saved.
to set the Pin Status you want. If you want to change the
16