Alarm Reminder; Setting The Current Time; Clock Am/Pm Setting - RNIB CC36 Instruction Manual

Alarm reminder

The clock's alarm will sound for one minute and then pause for four and a
quarter minutes. This process will be repeated five times and then stop, unless
you cancel it by pressing the large time announce button on the top of the
clock.

Setting the current time

In the next mode the clock says "clock hour" followed by the current clock hour
setting. Use the set button to advance the hours.
In the next mode the clock says "clock minute" and the current clock minute
setting. Advance this by using the set button. As with the alarm minute setting
procedure above, the clock minute setting can be speeded up by holding down
the set button for five announcements.

Clock am/pm setting

In the next mode the clock says "clock" then the current am/pm setting.
Change this by pressing the set button.
Pressing the mode button once more will return the clock to current time
announcement mode and can be used to confirm your time setting.
Special note
To confirm the alarm status, simply press the set button in the current time
announcement mode. The clock will announce the current alarm settings -
alarm sound, alarm on/off and the alarm time. This action will not change any
of the clock's settings.
The clock will keep time throughout the set up procedure described above and
the clock modes are listed in their order of appearance below: -
Current time announcement
Announce on/off
Alarm on/off
Alarm hour
Alarm minute
4