Setting The Alarm; Alarm Am/Pm Setting; Choosing The Alarm Sound - RNIB CC36 Instruction Manual

Setting the alarm

After pressing the mode button the clock now says, "alarm off". Alter this, if
desired, to "alarm on" by pressing the small, circular set button on the right.
Move to the next setting by pressing the square mode button and the clock will
say "alarm hour" followed by the actual alarm hour setting (e.g. "alarm hour
6"). Change this by pressing the circular set button. The clock will announce
the alarm hours as you cycle through them.
Each time the set button is pressed the alarm hour value will advance by one,
and the unit will say "hour", followed by the hour you have reached.
In the next mode the clock announces "alarm minute" followed by the current
alarm minute setting. Advance this by using the set button in the same way as
for the alarm hours. Note: If the set button is held down for five consecutive
announcements the alarm minutes will be advanced in five minute blocks (five,
ten, and so on) until the button is released. The next time you press the set
button the alarm minute setting will again advance by one minute.

Alarm am/pm setting

The next mode announces "alarm" followed by the current alarm am/pm
setting. This controls whether the alarm goes off before or after noon at the
alarm time already set. Toggle this setting between am and pm by pressing the
set button. The new setting will be announced each time.

Choosing the alarm sound

In the next mode the clock says "alarm" followed by the currently selected
alarm sound. Cycle through the various alarm sounds available by pressing
the set button repeatedly. You can choose from the following list of alarm
sounds:
a two-tone alarm
a mechanical bell sound
a horn sound
a cuckoo and
a beeping alarm.
3