Power Supply During Repairs; To Take Out A Cassette When Not Eject (Force Eject); Setting The "Forced Power On" Mode - Sony GV-HD700 Service Manual

1-1. POWER SUPPLY DURING REPAIRS

In this unit, about 10 seconds after power is supplied to the battery terminal using the regulated power supply (8.4V), the power is shut off so
that the unit cannot operate.
These following method is available to prevent this.
Method:
Use the AC power adaptor (AC-L15A/L100).

1-2. TO TAKE OUT A CASSETTE WHEN NOT EJECT (FORCE EJECT)

1 Refer to "2. DISASSEMBLY" to remove the mechanism deck block.
2 Supply +4.5V from the DC power supply to the loading motor and unload with a pressing the cassette compartment.

1-3. SETTING THE "FORCED POWER ON" MODE

It is possible to turn on power by adjustment remote commander (RM-95 or NEW LANC JIG).
Operate the VTR function using the adjustment remote commander.
1-3-1. Setting the "Forced VTR Power ON" Mode
1) Select page: 0, address: 01, and set data:01.
2) Select page: A, address: 10, set data:02 and press the "PAUSE (Write) " button of the adjustment remote commander.
1-3-2. Exiting the "Forced Power ON" Mode
1) Select page: 0, address: 01, and set data:01.
2) Select page: A, address: 10, set data:00 and press the "PAUSE (Write) " button of the adjustment remote commander.
3) Select page: 0, address: 01, and set data: 00.
GV-HD700/HD700E_L2
1. SERVICE NOTE
Loading motor
1-1
ENGLISH JAPANESE
ENGLISH JAPANESE
DC power supply
(+ 4.5Vdc)