Table of Contents
Advertisement
§ GENERAL ALIGNMENT INSTRUCTIONS
THIS RECEIVER IS TRANSISTORIZED. SPECIAL CARE MUST BE TAKEN WHEN SERVICING. READ THE FOLLOWING
NOTES BEFORE ATTEMPTING ALIGNMENT.
• Alignment requires an exact procedure and should be undertaken only when necessary.
• The test equipment specified or its equivalent is required to perform the alignment properly.The use of a
equipment which does not meet these requirements may result in improper alignment.
• Correct matching of the equipment is essential. Failure to proper matching will result in responses which
cannot represent the true operation of the receiver.
• The AC Power line voltage should be kept within from 110 to 220 volts while alignment.
• Do not attempt to connect or disconnect any wire while the receiver is in operation.
Make sure the power cord is disconnected before replacing any parts in the receiver.
TEST EQUIPMENTS.
DC POWER SUPPLY ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ
RF PATTERN GENERATOR¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ
DIGITAL MULTI METER ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ
WHITE BALANCE TESTER ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ¡ƒ
0V~30V/500mA Class.
PHILIPS PM-5518
FLUKE 8050A
NITSUKI 2840
6
Advertisement
Table of Contents
