Kenmore 795.7212 User Manual page 12

REFRIGERATOR INSTALLATION
REFRIGERATOR INSTALLATION
REFRIGERATOR INSTALLATION
NOTE: Removing the doors is always recommended when it is necessary to move the refrigerator through a narrow
opening. If it is necessary to remove the handles, follow the directions below.
HOW TO REMOVE FREEZER DOOR HANDLE
NOTE: Handle appearance may vary from illustrations on
this page.
Removing Freezer Drawer Handle
Removing Freezer Drawer Handle
Removing Freezer Drawer Handle
Loosen the set screws located on the lower side of the
Loosen the set screws located on the lower side of
handle with a 1/8 in. (3.1 mm) Allen wrench and remove
Loosen the set screws located on the lower side of the
the handle with a 1/8 in. Allen wrench and remove the
the handle.
handle with a 1/8 in. (3.1 mm) Allen wrench and remove
handle.
the handle.
NOTE: If the handle mounting fasteners need to be
NOTE: If the handle mounting fasteners need to be
tightened or removed, use a ¼ in. (6.4 mm) Allen
NOTE: If the handle mounting fasteners need to be
tightened or removed, use a ¼ in. Allen wrench.
wrench.
tightened or removed, use a ¼ in. (6.4 mm) Allen
wrench.
HOW TO REPLACE FREEZER DOOR HANDLE
NOTE: Handle appearance may vary from illustrations on
this page.
Replacing Freezer Drawer Handle
Replacing Freezer Drawer Handle Replacing Freezer Drawer Handle
Place the handle on the door by fitting the handle
footprints over the mounting fasteners and tightening
Place the handle on the door by fitting the handle
Place the handle on the door by fitting the handle
the set screws with a 1/8 in. Allen wrench.
footprints over the mounting fasteners and tightening
footprints over the mounting fasteners and tightening
NOTE: If the handle mounting fasteners need to be
the set screws with a 1/8 in. (3.1 mm) Allen wrench.
the set screws with a 1/8 in. (3.1 mm) Allen wrench.
tightened or removed, use a ¼ in. Allen wrench.
NOTE: If the handle mounting fasteners need to be
NOTE: If the handle mounting fasteners need to be
tightened or removed, use a ¼ in. (6.4 mm) Allen
tightened or removed, use a ¼ in. (6.4 mm) Allen
wrench.
wrench.
12