Sony DAV-HDX277WC Operating Instructions Manual page 84

Sound transmission is established as
follows (example):
with a specific S-AIR sub unit by performing the
pairing operation (page 86).
~../ - '
.../
. - /
./
.-/
../
--"
./.../
--"
p~ - /
P
---"
P
)
.~
---"
-....-..
) )
- /
'----'"
IDA I
I
IDA
I lOB I
S-AIR sub unit S-AIR sub unit S-AIR sub unit
This unit
IDA
Other
S-AIR main
unit
I
lOB
EQf'f~\'9:1~.;'Y.$f"'··
. .
;~nglbilrtQ'm·,;.,?~;l1··;.!%"r:/{/;~:.~.,··",,·,;·c,,; .~
For the S-AIR receiver
You can enjoy the system's sound by using the
S-AIR receiver. The S-AIR receiver can be
installed anywhere, regardless of the location of
the unit, for enjoying the system's sound in
another room.
84
US
iii!
• To confirm the current 10, perform Steps 1 to 7
above. When you pair the unit with the S-AIR sub
unit (page 86), [(PAIRING)] appears beside lD on
the display for selecting 10.
To set the ID of the surround
amplifier
1
Make sure that the SURROUND
SELECTOR switch of the surround
amplifier is set to SURROUND.
2
Set the S-AIR 10 switch of the surround
amplifier to match the 10 (A, B, or C) of
the unit.
3
Press POWER on the surround
amplifier.
When sound transmission is established,
the POWER / ON LINE indicator of the
surround amplifier turns green.
For details of the POWER / ON LINE
indicator, see "To check the transmission
status" (page 42).
To set the ID of the S·AIR
receiver
Refer to the operating instructions of the S-AIR
receiver.
-
• It is easy to set the same ID for the unit and S-AIR sub
unit to establish sound transmission. However,
neighbors may also receive your system's sound if
IDs are the same, or you may receive the sound from
neighbors. To prevent this, you can identify the unit
For details of the S-AIR receiver, refer to the
operating instructions of the S-AIR receiver.
1
Set the 10 of the S-AIR receiver to that
of the unit.
• To set the ID of the unit, see "To set the ID
of the unit" (page 83).
• To set the ID of the S-AIR receiver, refer
to the operating instructions of the S-AIR
receiver.
-
• When you are using another S-AIR sub unit,
such as a surround amplifier, do not change the
ID of the unit. Set the 10 of the S-AIR receiver
to the same 10 as the unit.
• When you pair the unit and another S-AIR sub
unit, such as a surround amplifier, by the pairing
operation, you need to perform the pairing
operation between the unit and the S-AIR
receiver. For details, see "Identifying the unit
with a specific S-AIR sub unit (Pairing
operation)" (page 86).
2
Press S-AIR MODE on the remote.
The S-AIR mode appears in the front panel
display. Each time you press S-AIR
MODE, the S-AIR mode changes.
• "PARTY": The S-AIR receiver outputs
sound according to function set on the
unit.
• "SEPARATE": You can set the desired
function for the S-AIR receiver while unit
functions do not change.