Calibrating The Appropriate Settings Automatically - Sony DAV-HDX277WC Operating Instructions Manual

g~us
Calibrating the
Appropriate Settings
Automatically
[AUTO CALIBRATION]
D. C. A. C. (Digital Cinema Auto Calibration)
can set the appropriate surround sound
automatically.
1m
• The system outputs a loud test sound when [AUTO
CALIBRATION] starts. You cannot turn the volume
down. Give consideration to children and neighbors.
• Make sure that the headphones are not connected to
the unit or surround amplifier. You cannot operate the
following Steps with the headphones connected.
1
Press FUNCTION +/- repeatedly until
"DVD" appears in the front panel
display.
2
Press 0 DISPLAY while the system is
in stop mode.
The Control Menu display appears on the
TV screen.
3
Press
~/.J,
to select" [SETUP],
then press
G.
The options for [SETUP] appear.
4
Press
~/.J,
to select [CUSTOM], then
press
G.
The Setup Display appears.
5
Press
~/.J,
to select [AUDIO SETUP],
then press
G.
The options for [AUDIO SETUP] appear.
6
Press
~/.J,
to select [AUTO
CALIBRATION], then press
G.
The options for [AUTO CALIBRATION]
appear.
7
Connect the calibration mic (supplied)
to the A.CAL MIC jack on the front
panel
Set up the calibration mic at the ear level
using a tripod, etc. (not supplied).
The front of each speaker should face the
calibration mic, and there should be no
obstruction between the speakers and the
calibration mic.
Calibration mic
E.g., DAV-HDX576WF
8
Press
+-1-+
to select [YES].
9
Press
G.
[AUTO CALIBRATION] starts.
Be quiet during the measurement.
1m
• Before [AUTO CALIBRATION], make sure
that the surround amplifier turns on and you
install the surround amplifier in the appropriate
location. If you install the surround amplifier in
an improper location, such as another room,
proper measurement will not be obtained.
• Avoid being in the measurement area and
making noise during the measurement (about 3
minute), to avoid measurement failure. During
the measurement, test signals are output from
the speakers.
• The environment of the room in which the
system is installed may affect measurements.