Lowrance HDS-5 Installation Instructions Manual page 20

After cutting the four corner holes, use a saw to cut along the dotted lines
from hole to hole. Be sure to cut along the inner dotted line, not the outer
This diagram shows the sequence for
securing the unit to the mounting surface.
1) Place the unit in the hole cut into the
mounting surface. 2) Use the provided
screws to secure the unit to the mounting
surface.
If water penetration is a concern, use a marine grade sealant between the unit
To remove the rest of
the material from the
mounting surface (in-
dicated by the shaded
area) cut along these
dotted lines.
solid line.
and mounting surface.
20
3) The face of the unit may
or may not have adhesive
strips around it. If it does,
peel the plastic cover from
the adhesive strips before
attaching the bezel. 4) Attach
the bezel to the unit.