Pod Transducer Trolling Motor Installation - Lowrance HDS-5 Installation Instructions Manual

Pod Transducer trolling motor installation

1. Slide the hose clamp
through the Pod transducer
brackets, as shown below.
The transducer should be mounted ahead of the trolling motor fin. Position
the transducer to so its face is pointing straight down when the trolling motor
Route the transducer cable along the trolling motor shaft. Use plastic ties
(not included) to secure the cable to the shaft.
The top of the
transducer is
curved to fit
the contour
of the trolling
motor.
2. Slip the clamp around the trolling motor, as
shown below. Tighten the hose clamp securely to
is in the water.
Cable ties
Hose
clamp
Transducer
You will need a hose clamp large enough to
fit over the trolling motor. The hose clamp
is NOT included with the Pod transducer.
Before you attach the transducer to the
trolling motor, make sure there is enough
slack in the transducer cable for the trolling
motor to turn freely.
the trolling motor.
14
Cable ties
Hose
clamp