Working With The Kneading Blade - Bifinett KH 700 Operating Instructions Manual

The cutting (II/III) and grating discs (IV/V) can be
used to slice or grate food stuffs quickly. The special
potato-chip disc (VI) enables you to make uniform
potato-chips at home. With the potato grater disc (I)
you can finely chop raw potatoes for the mixture,
and finely grate other vegetables or fruits as well.
• Place the mixing bowl 9 on
the food processor. Select the
appropriate disc.
• Place the disc with the lea-
ding edge (the side without
the ring marking on the cor-
ners) in the disc holder i.
• Push the other side (marked
with two circles at the cor-
ners) down until the disc
engages with a "click".
• Fit the retainer r to the drive
shaft 8. Insert thumb and in-
dex finger in the holes of the
disc holder i and place it on
the retainer r.
• Place the lid 0 on the bowl
9.
• You can now fill ingredients
through the filling shaft q.
• Set the speed controller 7 to level 3 (maximum
speed) for cutting and grating. Should you wish
to process soft fruit or vegetables you can also
select a lower speed.
• Slowly and gradually push the ingredients in the
filling shaft q using the pusher w.
Hints:
• Cut the food into pieces so that they fit through
the filling shaft q.
• Fill the filling shaft q evenly and do not exert ex-
cessive pressure.
• If you wish to process large quantities of food do
it in small batches and empty the mixing bowl 9
inbetween.

7.5 Working with the kneading blade

With the kneading blade t you can knead bread
dough and mix batter or cake mixture.
- 6 -
• To remove the disc from the
disc holder i, remove the
disc from the disc holder i
by pushing on the marked
side in an upward direction.
• Place the mixing bowl 9 on
the food processor.
• Place the kneading blade t
on the retainer r and fit on
the drive shaft 8.
• Add the ingredients to the
mixing bowl 9.