Airstream 2005 International Trailer Owner's Manual page 34

AIRSTREAM INTERNATIONAL TRAILER
SATELLITE ANTENNA WIRING
If you compare the two drawings above you'll see wiring for a satellite dish antenna is relatively simple.
Units have a faceplate with two coax cable hook-ups. The faceplate has a small coax cable jumper running
between the hook-ups to complete the cable TV circuit when in use. To install a satellite system use the
following procedure:
1. Remove the jumper wire from the coax faceplate.
2. Hook a portable dish into the Cable TV receptacle in the roadside rear underbelly compartment.
This feeds the dish signal to the input side of the faceplate.
3. Install the satellite receiver input and output into the dual coax faceplate.
To return to a cable TV system, remove the satellite receiver from the faceplate and reinstall the jumper
cable.
WARNING
: Check your escape window(s) to make sure they will open completely. Also
make sure the terrain under the window is suitable for rapid exiting.
C-6