Table of Contents
Advertisement
Factory Default
Note
To activate this feature the button must be pressed continuously
for 4 seconds. This is to avoid the possibility of activating this
feature accidentally.
Once the illuminator has been programmed, the settings will be stored in a
non-volatile (stored) memory. These settings are saved and reloaded if the
illuminator experiences loss of power. Press the RESET button to restore
the illuminator back to the factory default settings.
Disable Remote Control Setup
Note
To enable Programming Mode after remote setup has been
disabled, the illuminator must be powered off for at least
10 seconds. When turned on, the illuminator automatically
re-enters Programming Mode.
Disable remote setup once an individual illuminator has been programmed
and is delivering the required operating performance. This will help
to avoid tampering and the possibility of receiving commands when
programming other illuminators in close proximity.
Lock the illuminator settings by pressing the Disable Remote Setup button
continuously for at least 4 seconds.
If remote control setup is not disabled, the illuminator will remain in
Programming Mode for a pre-determined time of 4 weeks. After 4 weeks,
remote control setup will be automatically disabled.
Troubleshooting
Ensure all tests are undertaken by a qualified, trained engineer.
Ensure safe working practices are followed at all times.
AXIS T90B Series
27
Advertisement
Table of Contents
