Wall Mounting; Operating Features; Operation; Switching On And Off - E-Bench KH 2300 Operating And Safety Instructions Manual

4) Connect the two loudspeakers. The loudspeaker connections
Tips for setting up the loudspeakers:
If possible set up the speakers at head height
Do not cover the loudspeakers with curtains or other objects
Set up the loudspeakers on the shelf so that the front trim is flush with the front edge of the shelf.
You can place rubber pads under the loudspeakers to prevent them from turning.
5) Use cinch connectors
U
6) To receive FM radio signals connect a 75 Ohm aerial lead (house or cable) to the aerial connector socket
available, use the supplied wire aerial connected to the middle contact in the aerial connection
The aerial for medium wave reception is built into the equipment.
7) Now connect the mains plug into a 230 V socket.
8) Insert the batteries (not supplied) into the remote control (2x AA LR6 1.5 V):
– Open the cover on the back of the remote control
– Insert batteries. Note the correct polarities (see diagram on back of battery compartment)
– Close cover again

WALL MOUNTING

The Designer Audio Unit and the loudspeakers can be mounted on a wall.
Suitable screws and wall mountings are supplied. Place the pieces of equipment vertically on to a suitably strong wall.
The screw holes must be drilled 14 cm apart one under the other.
So that the screws can engage properly into the fastener
the screw heads must project no more than approx. 3 mm from the wall face.

OPERATING FEATURES

CD compartment
!
Display
@
Remote control signal sensor
#
Mono/stereo button
$
Tone selector
%
Mute switch
^
CD play/ pause
&
Device selector
*
RANDOM button
(
Forward button (*)
)
Band selector (FM / AM)
_
Protective cover
+
Pause button
(cassette only)
|
Stop/ eject button
`
Fast forward
(cassette only)
1
Rewind
(cassette only)
2
Play button
(cassette only)
3
Record button
(cassette only)
4
Headphones connector
5
The operating features marked with a (*) have several different functions depending on the device selected (e.g. radio or CD mode).
Please read the appropriate sections.
The operating elements
|

OPERATION

SWITCHING ON AND OFF

• If the mains plug is inserted, the equipment is in Stand-by mode. The operating display
• Press the ON/OFF button
• To switch back to Stand-by mode, press the ON/OFF button
• For longer periods of absence pull out the plug from the mains socket.
to connect an external device such as a turntable.
(only on FM radio)
(cassette only)
to and are exclusively for the operation of the cassette recorder.
4 I
[ » POWER / STAND-BY « ]
. The equipment is now in Operating mode. The operating display
E
are appropriately labelled (L=LEFT / R=RIGHT).
Y
on the rear of the Designer Audio Unit and loudspeakers,
P
Cassette compartment
6
Stop button (CD)
7
Reverse button (*)
8
Change display
9
TIMER button
0
SLEEP button
-
M-UP/REPEAT button (*)
=
MEMORY/CLK-ADJ button (*)
\
Reduce volume
Q
Increase volume
W
ON / OFF (standby) switch
E
Display
R
Mains plug
T
Loudspeaker connections
Y
Cinch connections for external devices (AUX)
U
Noise reduction system
I
Aerial connector
O
Fastening for wall mounted option
P
again.
E
11
. If these signals are not
O
.
O
(cassette only)
lights up red.
R
lights up green.
R