Table of Contents
Advertisement
4
Troubleshooting
20
Troubleshooting
Troubleshooting
Problem
No Power.
No sound.
The unit does not start
playback.
4
Radio stations cannot be
tuned in properly.
The remote control does
not work properly.
CM1530-BT_ADEULLK_ENG_6525.indd 20
Cause & Correction
y The power cord is not plugged in. Plug in the power cord.
y Check whether electricity failed. Check the condition by operating other
electronic devices.
y Check whether you select right function. Press FUNC. and check the selected
function.
y Speaker cables are not connected correctly. Connect the speaker cables
correctly.
y The volume is set to minimum. Use the Volume Knob to adjust the volume.
y An unplayable disc is inserted. Insert a playable disc.
y No disc is inserted. Insert a disc.
y The disc is dirty. Clean the disc. (Refer to the page 23)
y The disc is inserted upside down. Place the disc with the label or printed side
facing upwards.
y The antenna is positioned poorly. Adjust its position.
y The signal strength of the radio station is too weak. Tune to the station
manually.
y No stations have been preset or preset stations have been cleared (when
being tuned by scanning preset channels). Preset some radio stations, see
page15 for details.
y The remote control is not pointed at the remote sensor of the unit. Point the
remote control at the remote sensor of the unit.
y The remote control is too far from the unit. Operate the remote control within
about 16 ft (5 m).
y There is an obstacle in the path of the remote control and the unit. Remove
the obstacle.
y The battery in the remote control is exhausted. Replace the battery with new
one.
2014-01-13
2:03:38
Advertisement
Table of Contents
