Table of Contents
Advertisement
Exploded View/Disassembly&Assembly Instructions
― Assembly
1
( Remove the paper )
< 1. Remove the paper >
Shield Can Check & Key FPCB Attachment
1. Remove the protection paper on the back side of Key FPCB.
2. Attach the Key PCB on the shield can set to the hole. -> Check the 1 extraneous matter before attaching the shield can.
3. Check the position of volume key part FPCB properly.
2
< 1. LCD Sponge >
LCD Sponge & LCD Acrylic Tape Attachment
1. Attach the LCD sponge to the width of LCD
FPCB.
2. Attach the LCD acrylic tape within the silk line.
4
< Assemble Camera/Speaker >
Camera/Speaker Assembling
1. Remove the protection paper of camera FPCB fixing tape.
2. Insert the FPCB up to the guide line With regard to the insertion direction of camera and then close the
locker.
3. Insert the FPCB up to the guide line With regard to the insertion direction of speaker and then close the
locker.
( Check one extraneous matter )
< 2. Attach the Key FPCB >
< 2. LCD Acrilic Tape>
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
critical point
< 3. Check FPCB attachment >
3
< 1. Slide FPCB
Fixing Tape >
Slide/Camera FPCB Tape Attachment
1. Attach the fixing tape of slide FPCB within the
silk line.
2. Attach the fixing tape of camera FPCB within
the silk
line.
critical point
5-10
< 2.Camera FPCB
Fixing Tape >
< Check Guide Line >
< Close the Locker >
Advertisement
Table of Contents
