Tv-Mode Setup - Dreambox DM820 HD User Manual

Chapter 11

TV-Mode setup

With the Dreambox remote control you have the possibility to control the dreambox and your tv device
with only one remote control. In order that your tv device reacts to the signals of the remote control, you
have to program it before.
There are 3 options for programming the rcu:
1. Programming with Code
2. Programming by Learning function
3. Programming by Scan function
Please read the steps of each programming method carefully, before you proceed.
Programming with Code
In this programming method a manufacturer-specific code is used (refer to device list on
com).
1. Press the OK-Button and the TV-Mode-Button for ˜ 3 seconds.
2. Enter the desired 3-digit Code 000-999 with the Numeric-Keypad. Now press the Mute- or Volume
Button in order to check if the tv device responds to the just entered code. If there is no response,
please try it again with the next code from the list, according to the steps above.
3. If none of the given codes is suitable, please proceed with the chapter "Programming by Scan function".
If no code is entered within 6 seconds or the TV-Mode-Button is pressed, the remote control will
exit the programming mode automatically.
Programming by Scan function
In this programming method the dreambox rcu sends every second another shutdown-code to the tv device,
until the tv shuts off. Use this method of programming, if the Programming with Code wasn't successfully,
or the vendor of your specific tv device isn't listed.
1. Press the OK-Button and the TV-Mode-Button for ˜ 3 seconds.
69
www.leontechltd.