General International 15-035 MI Setup & Operation Manual page 14

Note: For stop installation, the stud has to be re-installed
with it's longer end threaded in as shown above.
5. Re-install the washer F, then re-install the stud as
shown above, threading its longer end in the sand-
ing head.
M
L
K
8. Loosen and remove bolt K and washer L from the
backstop M.
9. Place the workpiece stop against the workpiece
stop holder and use the washer and bolt to secure
in place as shown in N.
NOTE
For table installation, the stud is installed with the
shorter end threaded in as shown above.
14
J
6. Re-install the toothed nut D on the stud.
7. Slide the backstop holder J onto stud with nut and
secure in place using the previously removed han-
dle C, spring B and screw A.
N
10. Loosen the locking handle and adjust the po-
sitionning of the workpiece stop up or down along
the workpiece stop holder, making sure it clears
the sanding belt, then re-tighten the locking
handle.
Tip: Use 2 flat washers (3 mm thick approx.) placed under
the workpiece stop,
ance.
For stop installation, the stud has to be removed
and re-installed with the longer end threaded in as
shown above.
D
C
B
O
O
O
as a reference for appropriate clear-
A