Pacific Communications SmartIP-8SD User Manual page 24

Part 2 - Getting Started
2
Specify whether the system is connected to the
Internet and click Next.
If you have chosen No, wait for the test to finish
and then click Finish to exit Network Wizard.
3
Select Network Configuration and then click
Next. Select either Auto Configuration or Manual
Configuration and then click Test to test the
system's current network configuration.
This test must be performed before proceeding
to the next step.
If the NVR is on a network connected to a
network that has a DHCP server, selecting
Auto Configuration retrieves LAN settings
such as IP and DNS addresses automatically.
Selecting Manual Configuration, on the other
hand, lets you specify the settings manually.
UPnP support device not found. If this error
message is displayed, check to see if the IP
router (or NAT) supports UPnP and if UPnP
has been enabled. For more information about
the router's UPnP function, refer to the router's
operation manual.
24
4
Enter in the Device Name field the NVR name
to be registered on the FEN server and then click
Check to check its availability.
The device name you register on the FEN
server will be a unique name used to identify
the NVR. Once registered, the name can be
used to access the NVR directly from clients
such as the RASplusIP Check the name's
availability to complete the registration
process. The Finish button will then become
activated.
You will be prompted with an error message if
you do not enter a name for the NVR or enter
a name already registered on the FEN server.
Depending on the network environment,
FEN services may not be active and
therefore prevent the NVR from connecting
to the network. In this case, you will need
to manually configure the ports. For more
information on port configuration, refer to
refer to Network Setup on page 57.
5
Click Finish to exit Network Wizard.