Raveon RV-M7-UC-GX Quick Start Manual page 9

6.5. GPS Additional Commands
The following commands are unique to the –GX version of the M7.
When you execute any of these commands, the new parameter is
automatically stored in EEPROM.
Command Description
Command
Singe-hop repeat. Only applicable if repeater
function is enabled. (ATXR = 1)
ATHX
will repeat as programmed . 1 = will not repeat
any packet that has already been repeated.
Display GPS settings. Show an overview of
GX the current GPS features and configurations in
the M7 GX.
GPS Operation Mode. Read/Set the GX
GPS
version's Operating mode.
Reset all GPS (-GX version) parameters. Set
the GX version's Operating mode to GPS mode
GPS&F 4, and sets all GPS parameters to factory
defaults. It does not erase frequency or other
radio-related parameters.
IDLE TX Interval. Set the number of seconds
between position transmissions when the unit is
IDLERATE
idle (has not moved more than TRIGDX
meters).
Privacy Security Key Code. Set the
privacy key for this device. It must be the
same key as used on all other Raveon
KEYPHRASE products in your system. It secures radio
transmissions from unauthorized reception.
Set it to 0 to disable security encryption of
data.
ID Prefix. Set an ID prefix. The prefix is 1-8
characters that will be put in front of the ID
PREFIX when reporting an ID as a waypoint name. A
dash means no prefix. Default is a capitol letter
V.
Proximity Alert. Set a minimum proximity
distance. When any M7 GX with properly
configured ID codes and KEYPHRASE comes
within this many meters of this unit, a proximity
PROX
warning is triggered. The report interval will be
at the TXRATE setting, and report the proximity
warning at least 8 times or until the distance
between the two M7 GXs increases beyond the
PROX distance.
Enable -GX Repeating. This simple command
enables the repeater feature of the M7 GX, and
configures it for standard operation. The user
may alternately use the ATX and ATRX
REPEAT
commands, but they are more complicated to
use. This command enables the unit to repeat
all messages it receives, as long as the first
digit of the 4-digit ID matches its first digit. (It
M7 GX Quick Start Guide
Parameters
0 = repeater
0 or 1
-
0 - 6
-
0-9999
seconds
2-16
ASCII
character
s.
1-8 ASCII
characters
Set it to
"0" for no
prefix.
0-9999
0=feature
disabled
0 Off
1 0n
9
Raveon Technologies Corp.
Default
0
-
1
-
10
"RAVE
ON"
V
Disabl
ed (0)
0