Raveon RV-M7-UC-GX Quick Start Manual page 12

ATMK The network address mask. Default is F000. This means this unit will
receive all transmissions from any other unit with an ID beginning with
0 (0001 thru 0999).
KEYPHRASE Enter a security key code. Use any word or phrase 1-16 characters
long. It is case-sensitive. DO NOT FORGET WHAT YOU SET IT TO!
The KEYPHRASE is the only parameter that cannot be read out of the
M7 GX. It must be the same as the KEYPHRASE programmed into
all the other M7 GX transponders in your system. The factory default
KEYPHRASE is RAVEON, call capitols.
9. To see an overview of how the modem is configured, use the
SHOW command. To see an overview of how the GPS features
are configured, use the GX command.
10. Type the ATSV command to permanently save the new modem
parameters into FLASH memory.
Remember, that from the factory, all M7 GX modems are configured to
simply work. Plug in power and connect to the serial port at 4800 baud,
and the modems will communicate on the default channel. Change the
channel frequency to your specific frequency, and they will be ready to
work on your channel.
7.1. Enabling Repeater Features
Refer to the technical manual for advanced repeater configuration
instructions. To quickly enable repeating of all data sent from/to units 1-
999, use the REPEAT 1 command. This will enable the repeater
function, and configure it to repeat messages, position, and status
transmissions.
Set the Transmission Report rate
Use the TXRATE xx command to set the report rate, in seconds, for the
M7 GX transponder. For example, if you wish the M7 to report every 5
minutes, set the report rate to 300 seconds (TXRATE 300).
If the M7 GX should report position and status when it is moving, set the
TXRATE xx to the desired time between position transmissions. Then,
program the IDLERATE xx to the desired number of seconds between
reports when the unit is not moving (idle).
Important!: Set the minimum distance the unit must move for a
transmission occur with the TRIGDX xx command. If TRIGDX is set to
zero, then the unit will always report at the interval set with the TXRATE
xx command.
For example, to transmit every 2 minutes when idle, and every 10
seconds when moving more than 500 meters, use these commands:
IDLERATE 120 (
to set the idling update interval to 2 minutes.)
TRIGDX 500
(tells it to report at the IDLERATE if it does not move this
many meters)
M7 GX Quick Start Guide
12
Raveon Technologies Corp.