Table of Contents
Advertisement
Quick Links
"A" SERIES & "LEA" SERIES PUMPS
IMPORTANT SAFETY INSTRUCTIONS
When installing and using this electrical equipment, basic
safety precautions should always be followed, including the
following:
READ AND FOLLOW ALL
1.
INSTRUCTIONS.
2. WARNING : To reduce the risk of injury, do not permit
children to use this product unless they are closely
supervised at all times.
3.
CAUTION:
installed pools and may also be used with hot tubs and spas
if so marked. Do not use with storable pools. A permanently
installed pool is constructed in or on the ground or in a
building such that it cannot be readily disassembled for
storage. A storable pool is constructed so that it may be
readily disassembled for storage and reassembled to its
original integrity and has a maximum dimension of 18 ft.
(5.49m) and a maximum wall height of 42 in. (1.07m).
4. Do not install within an outer enclosure or beneath the
skirt of a hot tub or spa unless so marked.
SAVE THESE INSTRUCTIONS
5.
05/04
OWNER'S MANUAL
This pump is for use with permanently
1
.
97490010
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Aqua Flo "A" Series & "LEA" Series Pumps A Series
Summary of Contents for Aqua Flo "A" Series & "LEA" Series Pumps A Series
-
Page 1: Important Safety Instructions
“A” SERIES & “LEA” SERIES PUMPS IMPORTANT SAFETY INSTRUCTIONS When installing and using this electrical equipment, basic safety precautions should always be followed, including the following: READ AND FOLLOW ALL INSTRUCTIONS. 2. WARNING : To reduce the risk of injury, do not permit children to use this product unless they are closely supervised at all times. - Page 2 INSTALLATION & OPERATING INSTRUCTIONS GENERAL Your AQUA-FLO pump has been quality built and engineered to give maximum efficiency under normal water pumping conditions. Consult the manufacturer for any other applications. LOCATION OF PUMP For best pump performance, locate the system as close to the water source as possible.
- Page 3 Be sure motor is kept dry and covered. In mild climate area, when freezing may occur, run pump and filter equipment continuously to prevent freezing. MOTOR Your pump is equipped with a permanently lubricated, maintenance-free, heavy- duty industrial quality motor especially designed to withstand the heavy-duty requirements of swimming pool application.
- Page 4 TROUBLE SHOOTING PROBLEM SOLUTION If pump loses prime, Hair and lint pot cover is tight and o-ring is in place or if too many bubbles and free from defects. come through return Valves on suction and return lines are working line, check: properly and open.
- Page 5 ASSEMBLY INSTRUCTIONS FOR MOUNTING LIQUID END TO MOTOR STEP 1 Remove pump and motor from their boxes and check for any possible shipping damage. STEP 2 Place motor vertically with shaft end up, being careful not to damage motor end bell.
- Page 6 "A" SERIES REPLACEMENT PARTS Please refer to diagram located on page 7 Ref. Part No. Description Motor, 56 Frame, 'C' Face, Keyed Shaft 92520002 20002 Shaft, Extension, Solid End Shaft, Extension, Solid End 99730000 99730000 Screw, Socket Set, 1/4"-20 x 5/16" Screw, Socket Set, 1/4"-20 x 5/16"...
- Page 7 DIAGRAM – Please Refer to table located on page 6 AQUA-FLO, LLC P.O. BOX 2526 • CHINO, CALIFORNIA 91708 SHIPPING: 5651 SCHAEFER AVENUE • CHINO, CALIFORNIA 91710 TEL 909/591-7453 • FAX 909/627-5660 WWW.AQUA-FLO.COM...
- Page 8 “A” SERIES & “LEA” SERIES PUMPS LIMITED WARRANTY AQUA-FLO, LLC WARRANTS TO: the original retail purchaser only, that the products Aqua-Flo manufactures are free from defects in material and/or workmanship for a period of five years from date of purchase, not to exceed six years from date of manufacture, (pump seals warranty for 30 days).
Need help?
Do you have a question about the "A" Series & "LEA" Series Pumps A Series and is the answer not in the manual?
Questions and answers