eamlab Element 302 User Manual page 10

problem
No power on
No sound or sound very
low
Distorted sound
THL light and amplifier
no power output
THL light and amplifier
turn OFF
Trigger interconnection
no turn ON/OFF
amplifier
ILP led flashing
troubleshooting
Possible cause
The plug on the power
cord is not connected or
is not fully inserted .
The mains fuse is blown
Connecting signal Input
or output cables
incorrect
The source has an output
signal too high or output
amplifier clipping
Output relay open
Temperature much to
high
Cable KO or source
imcompatibilities
Output offset to much
high or power final stage
with problem
remedy
Securely connect the
plug or check the fuse on
the rear panel next to
the socket
Check the RCA or XLR
cables . Swicth XLR/RCA
incorrect position
Turn down the volume of
the source if it is
equipped with such
control
temperature is in
overload up to 90° .
when down to 80° relay
closed automatically
Temperature over 100°
Celsius. Amplifier turn on
automatically when
temperature down 70°
Check the cable or
connect the cable to
source and power amp
Turn off the machine. If
the problem persists,
contact an authorized
service center
10