Behringer Ultra Distortion UD300 Quick Start Manual

Thank you for showing your confidence in us by purchasing the BEHRINGER ULTRA
DISTORTION UD300. This high-quality effects pedal delivers two distortion pedals in
one—from blues-rock rhythms to searing leads. It features a mode switch that lets you
choose between two different basic distortion sounds. You'll achieve the right tone
for heavy metal leads, hard rock chordwork and much more.
Use the ULTRA switch to chose between the two different distortion modes.
Mode 1 provides warm and mellow distortion with flat frequency response.
Mode 2 delivers biting distortion with a mid range boost that is perfect for leads.
The LEVEL control adjusts the output level.
The TONE control allows you to shape your overall sound.
The DIST(ortion) control adjusts the amount of distortion effect.
The ON/BATT LED illuminates when the effect is activated. It also serves as a
battery level indicator.
Use the footswitch to activate/deactivate the effect.
Use this 1/4" TS IN connector to plug in the instrument cable.
The 1/4" TS OUT connector sends the signal to your amp.
Use the DC IN connection at the front of the unit to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or
replace the 9 V battery, press the hinges with a ballpen and remove the pedal cover. Be
careful not to scratch the unit.
The UD300 has no on/off switch. As soon as you insert the jack into the IN
connector, the UD300 begins running. When not using the UD300, remove
the jack from the IN connector. This extends the life of the battery.
ULTRA DISTORTION UD300
1. CONTROLS
Top view