Transformer, Power Supply Pcb And Back Plate Assembly - Kodak EKTAPRO 9020/CINE Service Manual

SM2547-1

TRANSFORMER, POWER SUPPLY PCB and BACK PLATE ASSEMBLY

It is easier to remove the complete TRANSFORMER, POWER SUPPLY PCB and BACK PANEL ASSEMBLY
1
. Remove the UPPER HOUSING. See page 4-1.
2
. Remove the CENTER HOUSING. See page 4-4.
3
. Remove the 4 SCREWS from the TRANSFORMER
4
. Remove the CONNECTOR P3 from the POWER SUPPLY PCB.
5
. Remove the NEUTRAL WIRE at the MECHANISM FRAME and the LAMP HOUSING ASSEMBLY.
6
. Disconnect POWER SUPPLY PCB from the MASTER BOARD PCB. Remove the TRANSFORMER and
the BACK PLATE ASSEMBLY.
7
. If needed, install new assemblies.
TRANSFORMER
POWER
SUPPLY
PCB
CONNECTORS(P3)
NEUTRAL
WIRES
BACK PLATE ASSEMBLY
Kodak AG, Stuttgart
NOTE
at the same time, to avoid needless removals.
figure 4-16
4-11
SCREW (4)
LAMP HOUSING ASSEMBLY
Service Manual
03/98