Retained Accessory; Power (Rap); Shifting Into Park - Chevrolet 2012 Suburban Owner's Manual

WARNING (Continued)
If the cord will not reach, use a
heavy-duty three-prong extension
cord rated for at least 15 amps.
4. Before starting the engine, be
sure to unplug and store the
cord as it was before to keep it
away from moving engine parts.
If you do not, it could be
damaged.
The length of time the heater should
remain plugged in depends on
several factors. Ask a dealer in the
area where you will be parking the
vehicle for the best advice on this.

Retained Accessory

Power (RAP)

The following vehicle accessories
can be used for up to 10 minutes
after the engine is turned off:
Audio System
Power Windows
OnStar System (if equipped)
Sunroof (if equipped)
These features work when
the key is in ON/RUN or ACC/
ACCESSORY. Once the key is
turned from ON/RUN to LOCK/OFF,
the windows and sunroof continue
to work up to 10 minutes until any
door is opened. The radio continues
to work for up to 10 minutes or until
the driver door is opened.

Shifting Into Park

WARNING
It can be dangerous to get out of
the vehicle if the shift lever is not
fully in P (Park) with the parking
brake firmly set. The vehicle can
roll. If you have left the engine
running, the vehicle can move
suddenly. You or others could be
injured. To be sure the vehicle will
not move, even when you are on
(Continued)
I n f o r ma t i o n P r o v i d e d b y :
Driving and Operating
WARNING (Continued)
fairly level ground, use the steps
that follow. If you have a
four-wheel drive transfer case
with a N (Neutral) position, and
the transfer case is in N (Neutral),
the vehicle will be free to roll,
even if the shift lever is in
P (Park). So, be sure the transfer
case is in a drive gear
N (Neutral). If you are pulling a
trailer, see Driving Characteristics
and Towing Tips on page 9 70.
Always set the parking brake.
1. Hold the brake pedal down, then
set the parking brake.
See Parking Brake on page 9 46
for more information.
2. Move the shift lever into the
P (Park) position by pulling the
shift lever toward you and
moving it up as far as it will go.
3. Be sure the transfer case is in a
drive gear not in N (Neutral).
9-27
not in