Table of Contents
Advertisement
10-78
Vehicle Care
A. Tool Container
B. Jack
C. End of the Jack
1. Turn the end of the jack (C)
counterclockwise to loosen it.
Remove the jack (B) from the
retaining bracket.
2. Remove the tool container (A).
3. Remove the tools and tire strap
from the tool container.
4. Place the tools next to the tire
being changed.
Removing the Flat Tire and
Installing the Spare Tire
1. Do a safety check before
proceeding. See If a Tire Goes
Flat on page 10 68 for more
information.
2. If the vehicle has wheel bolt
caps, remove the caps. Store
the caps with the wheel cover.
3. Use the fully extended wheel
wrench to loosen all the wheel
nuts one-half turn
counterclockwise. Do not
I n f o r ma t i o n P r o v i d e d b y :
remove them yet.
Notice: Make sure that the jack
lift head is in the correct position
or you may damage your vehicle.
The repairs would not be covered
by your warranty.
4. Position the jack lift head at the
jack location nearest the flat tire.
The location is indicated by a
mark on the bottom edge of the
vehicle. The jack must not be
used in any other position.
Raise the jack until it engages
with the jacking point.
Advertisement
Chapters
Table of Contents
