Table of Contents
Advertisement
2-4
Keys, Doors, and Windows
Pressing
may also arm the
theft-deterrent system. See
Anti-theft Alarm System on
page 2 10.
(Unlock): Press to unlock the
driver door or all doors. See Door
Unlock Options under Vehicle
Personalization on page 5 39.
The turn signal indicators may flash
and/or the horn may sound to
indicate unlocking. See Unlock
Feedback under Vehicle
Personalization on page 5 39.
Pressing
will disarm the
theft-deterrent system. See
Anti-theft Alarm System on
page 2 10.
(Remote Trunk Release):
Press and hold to unlock the trunk.
(Vehicle Locator/Panic
Alarm): Press and release one
time to locate the vehicle. The
exterior lamps flash and the horn
chirps.
Press and hold
for at least
two seconds to sound the panic
alarm. The horn sounds and the
turn signals flash until
again or the key is placed in the
ignition and turned to ON/RUN.
(Remote Vehicle Start): For
vehicles with this feature, press
and then
to start the engine from
outside the vehicle using the RKE
transmitter. See Remote Vehicle
Start on page 2 5 for additional
information.
The buttons on the keys are
disabled when there is a key in the
ignition.
Programming Transmitters to
the Vehicle
Only RKE transmitters programmed
to this vehicle will work. If a
transmitter is lost or stolen, a
replacement can be purchased and
programmed through your dealer.
I n f o r ma t i o n P r o v i d e d b y :
When the replacement transmitter is
programmed to this vehicle, all
remaining transmitters must also be
reprogrammed. Any lost or stolen
is pressed
transmitters will no longer work
once the new transmitter is
programmed.
Battery Replacement
The battery is not rechargeable. To
replace the battery:
1. Extend the key blade and open
the battery cover on the back of
the transmitter by prying it with a
finger.
2. Remove the used battery by
pushing on the battery and
sliding it toward the key blade.
3. Insert the new battery, positive
side facing up. Push the battery
down until it is held in place.
Replace with a CR2032 or
equivalent battery.
4. Snap the battery cover back on
to the transmitter.
Advertisement
Chapters
Table of Contents
